Step down Transformer

Autor

Beitrag

benkenobi
Hat sich gelöscht

#1 erstellt: 06. Jul 2005, 16:16

Hello people,
now i know most of u guys have been mulling around the idea of purchasing equipment from US and elsewhere but are concerned about the supply voltage...
well, below are pics of the transformer that i got on behalf of Junia for his outlaw preamp...
its a 350VA with a 230 primary to 120 secondary conversion..

My 20VA tranny is much smaller compared to this but u get the idea..
they also supply the basic mounting top and bottom plates(one rubber and one steel + bolt)

u guys want more info on this then i suggest u go to toroidal.com and check out their range...
This transformer costed Junia 1525 rupees..if u want a bill then they will charge u 12.5%KST...

here are pics of Junia's transformer

Cheers,
Sachi

Sonic_Master
Stammgast

#2 erstellt: 06. Jul 2005, 17:22

even here there are no pics man.... where are the links?

benkenobi
Hat sich gelöscht

#3 erstellt: 06. Jul 2005, 17:48

i don't understand...i can see the pics in my browser.....
can any of u see the pics or is it a problem with only Sandeep's browser?

[Beitrag von benkenobi am 06. Jul 2005, 17:50 bearbeitet]

Sonic_Master
Stammgast

#4 erstellt: 06. Jul 2005, 18:23

hi sachu,
I am using Firefox and i didnt find ur images but i have even checked that even in the internet explorer but i couldnt find it...

best way is through

www.imageshack.ws... and paste the links man so that no matter what browserprobs we can just access it

cheers
sandeep

benkenobi
Hat sich gelöscht

#5 erstellt: 06. Jul 2005, 18:38

hey sandeep,
i too use firefox and the pics are hosted using imageshack..
anyway..hope these work for u..

http://img98.imageshack.us/img98/7594/img01488cf.jpg

http://img98.imageshack.us/img98/6846/img01491gy.jpg

ojoi
Ist häufiger hier

#6 erstellt: 07. Jul 2005, 04:36

hi there,
just curious are you going to make an amplifier ?

and are you going to make speakers

benkenobi
Hat sich gelöscht

#7 erstellt: 07. Jul 2005, 04:42

Dear Ojoi,
at least, that's the plan!
How successful i will be i donot know...

Will be receiving the amplifier PCBs tonight..

This transformer is for Junia and is basically a step down tranny to facilitate operation of 120 volt equipment as here the mains are 230 volt..
Cheers,
Sachi

jsa_ind
Stammgast

#8 erstellt: 07. Jul 2005, 05:13

Dear Sachi,

Thanks a million for getting the transformer for me !

As soon as I hook up the Outlaw Preamp I shall let the forum know the good, the bad & the ugly !!

Thanks once again.

Regards,

Junia.

Sonic_Master
Stammgast

#9 erstellt: 07. Jul 2005, 05:31

Dear Junia,
Can u tell me what are the rating of ur preamp? power comumption as well as voltage input so that i can estimate how much is the headroom for the trans...

best regards
Sandeep

jsa_ind
Stammgast

#10 erstellt: 07. Jul 2005, 05:59

Dear Sandeep,

As soon as I unpack the stuff in Bangalore, I shall let you know.

Regards,

Junia.

karthikrajg
Neuling

#11 erstellt: 01. Aug 2005, 10:33

hi guys,

I am new to this forum.
I am building an amplifier on my own. Total output power of 30W. I had initially planned for a 50W amp. but it required a +/- 24V and around 8A(rms) supply. The cost of the supply was around Rs.2400. So i have decided to go for a lesser power amplifier. I would post my design soon on this forum.

regards,
karthik

Arj
Inventar

#12 erstellt: 01. Aug 2005, 21:01

do try out the sonic Impact based on the tripath chip..have just ordered one